There is a drive board in Hirundo's 1xN  MEMS switch module This Driver Board  provides the necessary drive circuitry for the 2D MEMS Chip, allowing the user to control four analog voltages between 0 and 60V that actuate the MEMS mirror. The required power supply for the driver PCB is 5V/12V and its internal HV boost circuit provides the 60V power supply to the HV DAC (AD 5504). The 26-pin connector on its back side is designed for connecting to the Raspberry Pi but it will work with any SPI hardware.

Fast switching time

Small size, high integration degree

Low Polarization sentivity

Packaging